I stated my opinion on another thread that I believe the #killroom walk-in fridge/freezer to be located in the Pegasus Museum building. I was asked by a fellow voater "where is the refrigeration equipment at Pegasus?" I set out to figure it out. This post is the result.

### The Comet Ping Pong Freezer ###

First let's look at https://voat.co/v/pizzagate/1544338 where /u/anolegion included an FBI affidavit concerning the CPP shooting event. The affidavit describes a walk-in freezer at Comet which is accessible by a rear exit.

This was part of my comment on the above:

A couple of supposed hoaxers made a video that captured all kinds of interesting tidbits. (Note: the tunnel scenes are alleged to have been edited in, so take with a grain of salt.)

This image is the 2:13 mark in which the back of CPP is shown. Now, revisiting this image of yours, you might see them [the rear exit and the freezer].

So that's the CPP Freezer -- about a 9' or 10' square walk-in freezer outside the restaurant's back door.

### The Pegasus Museum #killroom Freezer ###

This freezer is approximately 15'x25' and was given the hashtag 'killroom' by Alefantis' Instagram friend werkinonmahnightcheese.

/u/Yuke has done research instumental in identifying that the #killroom is located in the Pegasus Museum building. See: https://voat.co/v/pizzagate/1536880 - The Pegasus building - HOMe to the "Kill room" construction site and Square Form -and- https://voat.co/v/pizzagate/1543972 - Further proof/information on Pegasus (Great work!)

Now I think I have the missing piece - the answer to "where is the refrigeration equipment at Pegasus?" And it's mostly explained in THIS INFOGRAPHIC with some supporting notes below.

Note - We can now be reasonably assured that the infamous hole being admired by John Kreher and Matt Proper was dug in order to plumb the black ABS pipes from the evaporator units into the basement below. (There's probably a 2nd hole just out of camera frame in the foreground.)

Note - Source follows for my infographic statement that "PVC and ABS piping is never to be intermingled in a plumbing system."

"Under no circumstances may PVC and ABS pipe and fittings be co-mingled in the system."

Finally, I am in no way a refrigeration expert. I invite any of you who are to correct or clarify what we're seeing here.

And... get ready for flak from the shills. We're over the target!

Thanks!